Replacing The Lamp; Troubleshooting - Leonard LHN1313X Benutzerinformation

6. Turn the two fasteners by 90° and
remove them from their seats.
7. First lift carefully and then remove the
glass panel.
1

TROUBLESHOOTING

WARNING! Refer to Safety
chapters.
What to do if...
Problem
The cooking zones do not
operate.
The oven does not heat up.
90°
2
Possible cause
Refer to the operating instructions for the built-in cooking sur‐
face.
The oven is deactivated.
8. Clean the glass panels with water and
soap. Dry the glass panels carefully.
Do not clean the glass panels in the
dishwasher.
When the cleaning is completed, install
the glass panel and the oven door.
When installed correctly the door trim
clicks.
Make sure that you install the internal
glass panel in the seats correctly.

Replacing the lamp

WARNING! Risk of electric
shock.
The lamp can be hot.
1. Turn off the oven.
Wait until the oven is cooled down.
2. Disconnect the oven from the mains.
3. Put a cloth on the bottom of the cavity.
The back lamp
1. Turn the lamp glass cover to remove it.
2. Clean the glass cover.
3. Replace the lamp with a suitable 300
°C heat-resistant lamp.
4. Install the glass cover.
Remedy
Activate the oven.
Leonard 19
A