Replacing The Lamp; Troubleshooting - Leonard LBN1113X Benutzerinformation

7. First lift carefully and then remove the
glass panel.
1
8. Clean the glass panels with water and
soap. Dry the glass panels carefully.
Do not clean the glass panels in the
dishwasher.
When the cleaning is completed, install
the glass panel and the oven door.

TROUBLESHOOTING

WARNING! Refer to Safety
chapters.
What to do if...
Problem
The oven does not heat up.
The oven does not heat up.
The oven does not heat up.
The oven does not heat up.
90°
2
Possible cause
The oven is deactivated.
The clock is not set.
The necessary settings are
not set.
The fuse is blown.
When installed correctly the door trim
clicks.
Make sure that you install the internal
glass panel in the seats correctly.

Replacing the lamp

WARNING! Risk of electric
shock.
The lamp can be hot.
1. Turn off the oven.
Wait until the oven is cooled down.
2. Disconnect the oven from the mains.
3. Put a cloth on the bottom of the cavity.
The back lamp
1. Turn the lamp glass cover to remove it.
2. Clean the glass cover.
3. Replace the lamp with a suitable 300
°C heat-resistant lamp.
4. Install the glass cover.
Remedy
Activate the oven.
Set the clock.
Make sure that the settings
are correct.
Make sure that the fuse is
the cause of the malfunc‐
tion. If the fuse is blown
again and again, contact a
qualified electrician.
Leonard 17
A