e) Display of the remaining time until recording start/stop
• To call up the function menu, press the "DOWN" button (6).
• Press the "DOWN" button (6) repeatedly until "TIME START" or "TIME STOP" and the remaining time (in hours/
minutes or days) appear on the LC display.
Time durations below 24 hours are displayed in HH:MM format.
If the remaining time exceeds 24 hours, it will be displayed in days: " ".
• Once the recording starts/stops, the latest measurement is shown in the display.
• To go back to the function menu, press the "DOWN" button (6).
f) Enabling/disabling the alarm limit pause function
To enable/disable the alarm limit pause function during recording, the alarm limit must be enabled during the configu-
ration (see chapter "12 c) Measurement - Alarm Settings").
To enable/disable the limit pause function, press and hold down the "ENTER" button (8) for a few seconds.
Once the alarm pause function is enabled/disbaled, the latest measurement will be shown in the display.
Recorded values during activated pause function are shown in the report graph as usual. However, the
graph clearly shows when and for how long the pause function was enabled.
When the limit pause function is enabled during recording, there is no alarm indicator "
LED alarm status and the minimum and maximum values are not updated.
Keep the "ENTER" button (8)
pressed → pause on
Keep the "ENTER" button (8)
pressed → pause off
" or "
". The
55