Meaning Of The Led Signals; Reading The Data Logger; Mounting On The Bracket - VOLTCRAFT DL-131 LUX Bedienungsanleitung

11. MEANING OF THE LED SIGNALS

• REC (green) and ALM (yellow/red) are not lit/do not flash: Data logger is deactivated
• REC (green) flashes 3x: Logger starts; 1x short flash depending on the setting every
10/20/30 seconds: data is logged.
• ALM (red) flashes 1x for the set measuring rate: lower threshold undercut; 2x brief flashes
fort the set measuring rate: upper threshold exceeded
• ALM (yellow) flashes 1x for the set measuring rate: Battery is flat; 2x short flashes for the
set measuring rate: internal data storage is full

12. READING THE DATA LOGGER

1. Start the Voltsoft software and connect the data logger to the computer.
Follow the instructions of the software manual (from Chapter 6.8.3).
2. Disconnect the data logger from the USB port again after reading.

13. MOUNTING ON THE BRACKET

On the bottom of the datalogger is a thread (see image 1, pos. 6) to mount the datalogger e.g.,
to the bracket supplied or onto a tripod (not included). The bracket supplied can be fixed onto a
wall with the screws and dowels supplied.
The bracket has a ball joint to ensure the optimum adjustment of the datalogger. This position
can be fixed with the locking screw on the ball joint.
25