Led Display - VOLTCRAFT DL-201 Bedienungsanleitung

10. LED DISPLay

LED
REC ALM
REC ALM
REC ALM
REC ALM
Green > Red >
Green
36
Description
No LED flashes:
The recording has stopped.
The battery is flat.
The green LED flashes 1x: The record-
ing is running (the flashing interval can
be set in the PC software).
The green LED flashes 2x :The memory
is full (flashing interval 20 s).
The green LED flashes 2x within 5 s:
The meter waits for start of recording
after configuration.
The green LED flashes 6x within 3 s:
The device switches on.
The red LED flashes 1x: The wood
moisture low alarm set in the software
has been undercut (the flashing interval
corresponds to the scan rate).
The red LED flashes 2x: The wood
moisture high alarm set in the software
has been exceeded (the flashing interval
corresponds to the scan rate).
The green and red LEDs flash 1x at the
same time: The battery voltage is less
than 2.9v (The flashing interval is 18 s)
The green and red LEDs flash at the
same time: The recording has stopped.
The recording is started.
Measure
The recording has not been
started yet.
Start recording.
Insert a new battery.
Push the button "START/
STOP" (3) for approx. 3 s to
start/stop the recording.
The data can be downloaded
onto the computer:
Push the button "START/
STOP" (3) until the green
LED starts to flash.
Replace the battery.
You can download the
recorded data onto the
computer.