Beem CM1131A-GS Bedienungsanleitung Seite 23

23
Inserting the Filter
1. Open the fi lter compartment (12) .
2. Place the fi lter insert into the fi lter compartment if necessary.
3. Insert a paper fi lter (1x4) or similar fi lter into the fi lter insert (Picture C).
4. If the device is to be used with coffee powder, fi ll the fi lter.
5. Place the lid on the fi lter insert.
6. Close the fi lter compartment again. It must engage.
Setting the Number of Cups
Use the dial (17) to set the number of cups you want (2 – 10 cups). This setting is only
required for making coffee with coffee beans.
"Added Flavour" Function
When making coffee with coffee beans, you can choose between mild coffee and strong coffee.
When the coffee machine is activated, the setting MILD (15) is automatically selected. The control
lamp in the MILD button lights up. If you want to have stronger coffee, press the STARK (strong)
button (16). This extends the brewing period and your coffee will have a stronger fl avour. The
control lamp in the STARK (strong) button lights up.
The "added fl avour" function remains saved until the MILD button has been pressed again
or the device has been disconnected from the mains power.
Keep-Warm Function
The device has an automatic keep-warm function. The hotplate (14) remains switched on for
approx. 35 minutes after each brewing process.
To end the keep-warm function prematurely, press the ON / OFF button (19).
Drip Stop
The device has a drip stop (7) which prevents water from dripping out of the fi lter insert when
the glass jug (13) has been removed from the device.
When the device is in operation, the fi lter compartment (12) must be closed and the glass jug
with the lid placed on it must be placed beneath the fi lter compartment. The lid of the glass jug
pushes the drip stop upwards and the coffee can fl ow from the fi lter through the lid into the glass
jug.
During the brewing process, the glass jug must not be removed from the device for longer
than 30 seconds as otherwise the fi lter could overfl ow.
EN