Panasonic ER5209 Bedienungsanleitung Seite 3

Charging
1. Set the switch
to "0•charge",
and insert the
power cord into
the clipper.
• The charging time is 8 hours.
• 1 full charge will provide approximately 35 minutes of continuous
operation.
Inserting the attachment
1 2 0/30/40mm, 50/60/70mm comb attachments
1. Adjust the attachment to the desired
trimming height by sliding it until it
clicks while the switch is in "0•charge".
• Set the attachment to the correct position.
Otherwise you cannot set the switch to "1".
• Actual hair length will be a little longer than
the height you set.
ER5209(EU).indb 3
Downloaded from www.Manualslib.com
2. Connect the AC 3. Disconnect the
adaptor into an AC adaptor
outlet. The from an outlet
charging when charging
indicator lamp is completed.
will light up.
manuals search engine
1 3 /6mm, 9/12mm, 15/18mm comb attachments
6mm
9mm
3mm
3/6mm
12mm
9/12mm
18mm
15/18mm
15mm
1. Select the 2. Mount the
cutting heights attachment to
indicated on the the clipper as
insides and illustrated.
sides of the
attachments.
1 N atural cutting attachment
This attachment allows thinning of hair by cutting
from the inner side. Hair volume is reduced, and hair
tips are trimmed at various lengths to leave a natural
look. Desirable hair lengths for this attachment:
30 mm-70 mm (hair lengths shorter than 30 mm may
be too short to cut in some situations.)
1 T hinning Attachment
1. Insert the attachment
over the trimming blades
until it clicks as
illustrated.
3. To remove the
attachment
from the clipper
2. To remove the
attachment, push both
sides while pulling the
attachment.
3
2007/12/20 14:56:22