IKEA IWM60 Handbuch Seite 21

ENGLISH
Problem Possible cause
The filter in the inlet hose or the in-
let valve filter are blocked (The red
indicator light of button 4 blinks).
The door is not properly closed
(The red indicator light of button 4
blinks).
The drain hose is squashed or
kinked (The red indicator light of
button 4 blinks).
The appliance The drain filter is clogged (The red
does not emp- indicator light of button 4 blinks).
ty:
An option or a programme that
ends with the water still in the tub
or a that eliminates all the spinning
phases has been selected.
The electronic unbalance detection
device has cut in because the laun-
dry is not evenly distributed in the
drum. The laundry is redistributed
The appliance
by reverse rotation of the drum.
spinning phase
This may happen several times be-
starts late or
fore the unbalance disappears
does not start:
and normal spinning can resume.
If, after 10 minutes, the laundry is
still not evenly distributed in the
drum, the appliance will not spin.
Too much detergent or unsuitable
detergent (creates too much foam)
has been used.
Check whether there are any leaks
from one of the inlet hose fittings. It
is not always easy to see this as
the water runs down the hose;
There is water
check to see if it is damp.
on the floor:
The drain or inlet hose is dam-
aged.
The cap on the emergency empty-
ing hose has not been replaced or
the filter has not been properly
screwed in after cleaning action.
Solution
Clean the water inlet filters. (See
"Cleaning the water inlet filters"
for more details).
Close the door firmly.
Check the drain hose connection.
Clean the drain filter.
Select the draining or spinning
programme.
Redistribute the load manually or
load more laundry and select the
spin programme.
Reduce the detergent quantity or
use another one.
Check the water inlet hose connec-
tion.
Replace it with a new one (check
with the After Sales Service the
right spare part number).
Refit the cap on the emergency
emptying hose or screw the filter
fully in.
21