IKEA IWM60 Handbuch Seite 19

ENGLISH
5
6
Cleaning the water inlet filters
If the appliance takes long to fill with water
or doesn't fill, the starting button indicator
light blinks in red. Check if the water inlet fil-
ters are blocked (see chapter "What to do
if..." for more details).
Proceed as follows:
1
Use a pencil to
check whether the
pump wheel right at
the back of the
pump housing can
turn. (It is normal for
the pumping wheel
to turn jerkily.) If the
pumping wheel
cannot be turned,
please contact the
After Sales Service.
Put the cap back on
the emergency
emptying hose and
place the latter
back in its seat.
Screw the pump
fully in.
• Turn off the water
tap.
• Unscrew the hose
from the tap.
• Clean the filter in
the hose with a
stiff brush.
• Screw firmly the
inlet hose back
onto the tap.
2
• Unscrew the hose from the appliance.
Keep a rag nearby because some wa-
ter may flow.
• Clean the filter in the valve with a stiff
brush or with the piece of cloth.
3
35° 45°
The dangers of freezing
If the appliance is exposed to temperatures
below 0°C, certain precautions should be
taken.
• Turn off the water tap.
• Unscrew the inlet hose.
• Place the end of the emergency emptying
hose and that of the inlet hose in a bowl
placed on the floor and let water drain
out.
• Screw the water inlet hose back on and
reposition the emergency emptying hose
after having put the cap on again.
• When you intend to start the appliance
up again, make sure that the room tem-
perature is above 0°C.
19
• Screw the hose
back to the appli-
ance turning it to
the left or the
right to suit the
installation. Tight
the locknut cor-
rectly to prevent
water leaks.
• Turn on the water
tap.