Sauna Assembly - Tylo Prime+ 1814 Benutzerhandbuch

_________________________________________________________________________
Floor Panel (Box #1):
• Locate the Floor Panel on a level surface 8-15 cm (3-6 inches) from wall and no more than 150
cm (5 ft) from 230 Volt AC / 10 amp dedicated receptacle.
• Position the Floor panel so that the Ceramic tiles / IR Floor Heaters are to the front of the room
Note: place the Ceiling, Bench Skirt and Bench to the side until the appropriate steps.
Note: place the power cord on the ground to the side of the floor; be sure that all wires and
connectors on the sauna floor are clear of the slots.
Note – Do NOT Plug the Sauna Room 230 VAC Power Cord into the Outlet Yet!
4 Person Infrared Sauna Prime+ 1814
Sauna Assembly Instructions
Page 4 131007
Rev. 1