Electrical Connections (inside Ceiling-Left front corner):
Near the Touch Screen harness in Ceiling connect Left
•
Wall wire #3 to Ceiling wire #3.
Connect Left Wall wire F to Ceiling wire F.
•
Connect Left Wall wire E to Ceiling wire E.
•
Electrical Connections (inside Ceiling-Left middle side & Right middle side-not pictured):
Connect wire # 7 from Left Wall panel to ceiling wire #7.
•
Connect wire #7 from Right Wall panel to ceiling wire #7.
•
Electrical Connections (inside the Ceiling-Right front corner):
Refer to picture below; remove the radio antenna from the Ceiling hatch by pulling out wire.
•
Spread blue antenna wires and lay across the roof of the sauna.
•
Sauna Room 230 Volt AC Power Cord:
• Plug the Sauna room power cord into the 10 amp wall receptacle as noted in page 3
Note: It is important that the sauna be plugged into a dedicated outlet of the correct rating. Plugging your
sauna into a shared circuit through can cause poor performance, circuit breaker tripping, or overheating
of the circuit.
4 Person Infrared Sauna Prime+ 1814
Page 15
131007
Rev. 1