Operation; Dmx-512 Connection / Connection Between Fixtures - EuroLite HPS-1500 Bedienungsanleitung

Mount the device to your trussing system using an appropriate clamp.
For overhead use, always install a safety-rope that can hold at least 12 times the weight of the fixture. You
must only use safety-ropes with quick link with screw cap. Pull the safety-rope through the attachment eyelet
and over the trussing system or a safe fixation spot. Insert the end in the quick link and tighten the safety
screw.
The maximum drop distance must never exceed 20 cm.
A safety rope which already hold the strain of a crash or which is defective must not be used again.
Adjust the desired inclination-angle via the mounting-bracket and tighten the fixation screws.
Connect the fixture to the mains with the power-plug.
The occupation of the connection-cables is as follows:
Cable Pin
Brown Live
Blue Neutral
Yellow/Green Earth
The earth has to be connected!
If the device will be directly connected with the local power supply network, a disconnection switch with a
minimum opening of 3 mm at every pole has to be included in the permanent electrical installation.
In general, lighting effects should not be connected to dimming-packs.
Before taking into operation for the first time, the installation has to be approved by an expert!

OPERATION

After you connected the effect to the mains, the HPS-1500 start running. The ventilation fans begin to rotate
and the display lights up.

DMX-512 connection / connection between fixtures

RGB
DMX C&B
SIGNAL
COLOR
MODE UP DOWN
The wires must not come into contact with each other, otherwise
International
L
N
DANGER TO LIFE!
RGB
DMX C&B
SIGNAL
COLOR
MODE UP DOWN
120 Ohms
the fixtures will not work at all, or will not work properly.
DMX
SIGNAL
MODE UP DOWN
19/43
RGB
C&B
COLOR
DMX-512 Controller
41601025X98NXS_V_1_0.DOC