Demo Mode Function - Saeco HD8914 Bedienungsanleitung

Problem
The AquaClean filter is
installed, but the
descaling message
appears.
The descaling message
appears before
AquaClean filters were
replaced.
The AquaClean filter does
not fit.
There is water under the
machine.

Demo mode function

Cause
After filter replacements, you need
to descale the machine.
You did not activate the AquaClean
filter correctly during first installation.
You placed the AquaClean filter after
having used the machine for a while.
You did not activate the replacement
filter in the machine menu.
You did not replace the filter when
the filter symbol started flashing.
You need to remove air from the
filter.
There is still water in the water tank.
You try to install another filter than
the AquaClean filter.
The rubber o-ring is not attached to
the AquaClean filter.
The drip tray is too full and
overflowed.
The machine is not placed on a
horizontal surface.
The machine is provided with a demo mode function.
Press and hold the STANDBY button for more than
the demo mode function.
English
Solution
5irst descale the machine and
then install a new AquaClean filter.
This will reset the filter counter to
/ . Always confirm filter
activation in the machine menu
see 'Activating the AquaClean
filter ' , also after filter
replacement.
5irst descale the machine and
then install a new AquaClean filter.
Always activate the filter in the
machine menu.
Let air bubbles come out of the
filter.
Empty the water tank before you
install the filter.
Only the AquaClean filter fits into
your machine..
Check the packaging for the o-ring
and attach it to the AquaClean
filter.
Empty the drip tray when the 'drip
tray full' indicator pops up through
the drip tray. Always empty the
drip tray before you start descaling
the machine.
Place the machine on a horizontal
surface so that the 'drip tray full'
indicator works properly.
seconds to enter