Disassembling The Automatic Milk Frother; Descaling Procedure - Saeco HD8914 Bedienungsanleitung

1
1
2

Descaling procedure

Disassembling the automatic milk frother

Remove the automatic milk frother from the hot water/steam dispensing
spout. Remove the rubber grip from the hot water/steam dispensing
spout.
Warning: The steam wand can be hot after use.
Remove the suction tube.
Disassemble the milk frother, by pressing on the sides
lower part from of the upper part
Remove the rubber lid.
After cleaning, reassemble the milk frother by following the steps above
in reverse order.
When the display shows 'START CALC CLEAN', you need to descale the
machine. If you do not descale the machine when this message appears on
the display, the machine stop working properly. In that case, repairs are not
covered by the guarantee.
Only use Saeco descaling solution to descale the machine. Saeco descaling
solution is designed to ensure optimal performance of the machine. The use
of other products may damage the machine and leave residues in the water.
You can buy Saeco descaling solution in the online shop at
www.shop.philips.com/service. The descaling procedure lasts
and consists of a descaling cycle and a rinsing cycle. You can pause the
descaling or rinsing cycle by pressing the ESC button. To continue the
descaling or rinsing cycle, press the OK button.
and pulling the
.
English
minutes