Preliminary Operations; Positioning; Water Tank Filling; Coffee Bean Hopper Filling - Saeco Incanto HD8914 Handbuch

4.

Preliminary operations

4.1

Positioning

H1
L1
W2
W1
L2
4.2 Water tank filling
4.3 Coffee bean hopper filling
4.4

Plug in and start

4.4.1

Demo mode function

DEMO MODE ON
Incanto_AMF_EN-IT-DE_Rev01.indb 5
Make sure to read the "3. Safety" chapter.
To facilitate the use of the machine, it should be placed in an appropriate location that
provides adequate space to operate.
Working spaces
L1 L2
150 mm 221 mm
Unpacking and placement
The original packaging was designed and produced to protect the machine while
being moved; it is recommended to keep it, in case the machine needs to be moved
again.
Remove the machine from its packaging.
>
> Choose a secure and horizontal surface away from heat sources and out of the
weather, in a sufficiently lit and hygienic room, next to an easily accessed power socket.
> Position the machine allowing for working spaces.
Lift the lid of the water tank.
>
> Lift the water tank by its handle.
Rinse the water tank with cold water.
>
Do not fill the water tank with hot, boiling or carbonated water or with other liquids
that might damage the tank and the machine. Use fresh water every time you use
the machine.
> Fill the water tank with fresh cold water to the MAX level.
Put the tank back into the machine, checking that it is fully settled.
>
> Lift the coffee bean hopper lid.
Do not place too many coffee beans in the coffee bean hopper, so as to avoid
damaging grinding performance.
Coffee powder, soluble coffee, raw coffee and other substances, if placed in the coffee
bean hopper, may damage the machine. Always fill the coffee bean hopper with roasted
coffee beans only. Do not fill it with green, caramelised or flavoured coffee beans.
> Pour the coffee beans slowly in the coffee bean hopper and close the lid.
Insert the plug into the socket located on the back of the machine.
>
Insert the plug at the other end of the power cord into a wall socket with suitable
>
power voltage, as shown in the tag inside the service door.
Turn the main switch to the ON position to turn the machine on.
>
> The STAND-BY button is flashing. Press the button to turn on the machine. The
display shows that it is necessary to prime the circuit: proceed as described in the
"5.2 First start" chapter.
Keeping the STAND-BY button pressed for over 8 seconds causes the DEMO MODE
function to start.
The machine is provided with a demo program.
Keeping the STAND-BY button pressed for more than 8 seconds launches the demo
>
program.
To exit the demo mode, turn the machine OFF and ON using the main switch.
>
W1 W2
430 mm 150 mm
ENGLISH
H1
340 mm
5
27/03/15 09:57