Saeco HD8914 Bedienungsanleitung Seite 34

English
Problem
The AquaClean filter
cannot be activated as the
tick does not appear on
the display.
The AquaClean filter
cannot be activated and
the machine asks for
descaling.
The AquaClean filter icon
does not appear on this
display after I replaced
the filter.
Cause
The type of milk used is not suitable
for frothing.
A filter has just been activated.
You have already replaced
AquaClean filters. After
replacements you need to descale
the machine.
The filter has not been replaced in
time after the AquaClean water filter
signal flashed and the capacity
dropped to %.
The filter has not been installed
during first installation but after
having brewed approx.
based on ml cups . The machine
has to be completely limescale-free
before installing the AquaClean filter.
The new or replaced AquaClean filter
was not activated via the machine
menu. Also after replacing the filter,
you need to confirm activation via
the machine menu.
You did not confirm activation via the
machine menu.
Solution
Different types of milk result in
different amounts of froth and
different froth qualities. We have
tested the following milk types
which proved to deliver a good
milk froth result: semi-skimmed or
full-fat cow's milk, soy milk and
lactose-free milk. Other types of
milk have not been tested and
may result in a small amount of
milk froth.
You have to dispense at least
cups of
can activate a new filter. Be careful
when you activate a new filter; the
filter counter will increase
automatically.
Descale your machine first and
filter then install the filter. Always
activate the AquaClean filter in the
menu see 'Activating the
AquaClean filter ' . Also do this
when you replace the filter.
Descale your machine first and
install the filter.
5irst descale the machine and
then install a new AquaClean filter.
coffees After descaling, the filter counter is
reset to / . Always confirm filter
activation in the machine menu,
also after filter replacement.
Descale your machine first. Then
activate the AquaClean filter in the
menu see 'Activating the
AquaClean filter ' . Also do this
when you replace the filter.
Confirm the activation of the filter
via the machine menu see
'Activating the AquaClean filter ' . If
the display shows 'START CALC
CLEAN' you first need to descale
the machine. Remove the
AquaClean filter before you do
and reinsert it afterwards.
ml each before you