Saeco HD8914 Bedienungsanleitung Seite 31

Error code
Troubleshooting
Troubleshooting
Problem
The machine does not
switch on.
The machine is in DEMO
mode.
The drip tray is quickly
filled.
Problem
Water circuit problem
The machine is
overheated.
If the above solutions do not help to remove the error code icon from the
display and bring the machine back to normal working order, contact the
Philips Saeco hotline. Contact details can be found in the warranty booklet
or on www.saeco.com/support.
This chapter summarizes the most common problems you could encounter
with the machine. If you are unable to solve the problem with the
information below, visit www.saeco.com/support for a list of frequently
asked questions or contact the Consumer Care Center in your country.
Cause
The machine is disconnected or the
main switch is in O55 position.
The standby button has been
pressed for more than
This is normal. The machine uses
water to rinse the internal circuit and
brew group. Some water flows
through the internal system directly
into the drip tray.
Cause
There is air in the water
circuit.
This can have several
causes.
Solution
Check if the mains cord is inserted
correctly
Make sure the main switch is in ON
position.
Switch the machine off and then
seconds. on again using the main switch on
the back of the machine.
Empty the drip tray when the 'drip
tray full' indicator pops up through
the drip tray cover.
Place a cup under the dispensing
spout to collect rinsing water.
English
Possible solution
Remove and place back
the water tank a couple
of times. Make sure you
insert it into the
machine properly.
Check if the water tank
compartment is clean.
Switch the machine off
and switch it back on
again after minutes.
Try this or times.