Before Use - cecotec TOTALPURE 3IN1 CONNECTED MAX Bedienungsanleitung

ENGLISH

2. BEFORE USE

Take the product out of the box.
Remove all packaging material and save the original box.
Make sure all parts and components are included and in good conditions. If any visible signs
of damage are observed, contact the Technical Support Service immediately.
Fig. 18.
When installing the device at home, remember to keep a safety distance from the device to
the walls and other objects. Do not cover it.
3. OPERATION
Fig. 3.
Press the On/off button to turn the device on and off.
Fig. 4.
Press the Sleep mode button on the remote control to turn the fan speed to minimum, the
display will show L. To exit the Sleep mode, press the Sleep mode button again or the fan
speed increase button.
Fig. 5.
Press the Turbo mode button on the remote control to activate the Turbo mode, the display
will show H, and the fan speed will turn to maximum. To exit the Turbo mode, press the Turbo
mode button again or the fan speed increase button.
Fig. 6.
Press the Oscillation button to activate the oscillation function. The device can swing left and
right up to 80º. Press the Oscillation button again to stop this function.
Fig. 7.
Press the sound button to activate or deactivate the device's sound.
Fig. 8.
Under Cool mode, the LED light indicator will turn on blue.
Press the Cool mode button to activate or deactivate this mode.
Note: The default start mode is the Cool mode.
Fig. 9.
Press the "+" button on the remote control to increase the fan speed. Press the "-" button to
decrease the fan speed.
The Cool mode has 9 speed levels. The Heat mode has 4 speed levels.
Fig. 10.
When the Heat mode is activated, the numbers will be displayed in orange colour.
Press the Heat mode button to activate this mode.
Note: There is no Turbo or Sleep function under Heat mode.
Fig. 9.
36 TOTALPURE 3IN1 CONNECTED MAX
Under the Heat mode, use the "+" and "-" buttons on the remote control to set the desired
temperature (1 ºC-30 ºC).
Note: These buttons will not work under the Cool mode.
Fig. 11.
Press the Timer button on the remote control to program the device from 1 to 8 hours.
Filter replacement
This device is equipped with a purifying air filter.
To replace it, follow the below instructions.
Fig. 15.
Fig. 12.
Rotate the top cover of the main body anticlockwise to unlock it and pull the filter out.
Fig. 14.
Separate the assembled top cover from the filter.
Assemble the new filter to the top cover of the main body.
Fig. 16.
Assemble the new filter and the cover back onto the main body and turn it clockwise until
fixed.
Using the device from the control panel
Fig. 17.
Connect the device to a power supply and turn the power switch on. The device will enter
standby mode.
Press the power button to activate the fan mode. Press and hold the power button for 2
seconds to stop the fan mode.
While the device is operating, press the power button to select the desired fan speed level,
from 1 to 9.
Oscillation
Press and hold the power button on the control panel for 1 second, the device will beep once,
and the fan will start oscillating.
Press and hold the power button on the control panel for 1 second, the device will beep once,
and the fan will stop oscillating.
Heat mode
Press the Heat mode button on the remote control or set it on the main panel, the display will
show the room temperature.
Use the "+" and "-" buttons on the remote control to set the desired temperature from 1 ºC to
30 ºC. The temperature digits will blink.
Note: The set temperature should be higher than the room temperature one in order for the
Heat mode to operate properly.
ENGLISH
TOTALPURE 3IN1 CONNECTED MAX 37