Layout; Items Supplied; Intended Use - Parkside PDT 40 A1 Bedienungs- Und Sicherheitshinweise Originalbetriebsanleitung

Anleitung_LB7_4137765:_
GB/
CY
In the workplace, carry the stapler only by its
■
handle and ensure that the trigger is
inactivated.
Make allowance for the workplace
■
conditions. Staples can potentially go
straight through thin workpieces or they can
slide off workpieces when working on
corners and edges, thus putting persons at
risk.
For you own personal safety, always use
■
suitable protective equipment such as, for
example, hearing and eye protection.
Check that the trigger catch functions
■
correctly every time before you use the
equipment. You are allowed to start using
the equipment only if the device functions
perfectly.
This equipment is not suitable for the following
work:
If changing from one stapling point to
■
another involves moving about on platforms,
steps, ladders or any other structures similar
to ladders such as, e.g. roof battens.
Sealing of boxes or crates.
■
Fitting of transportation braces, e.g. to
■
vehicles and wagons
Do not lose this safety information.
Residual risks
Even if you use this tool in accordance with
instructions, certain residual risks cannot be
eliminated. The following hazards may arise in
connection with the equipment's construction
and layout:
1. Risk of pinching.
2. Risk of injury from staples.
3. Damage to hearing, if no suitable ear
protection is applied.
4. Health damage caused by hand-arm
vibrations, if the equipment is not properly
guided and maintained.
8
Downloaded from www.Manualslib.com
09.02.2011 15:53 Uhr
manuals search engine
Seite 8
3. Layout (Fig. 1/8)
A Trigger lever
B Compressed air connection
C Magazine lever
D Magazine cover
E Magazine
F Level indicator
G Depth setting
H Trigger catch
I Cover plate (external)
J Cover plate (Internal)
K Swivel air-outlet
4. Items supplied (Fig. 2)
L Safety goggles
M Special compressed air oil
N Allen key, 3 mm
O Allen key, 4 mm
Not illustrated:
250 x 15 mm, 25 mm, 40 mm, 50 mm nails
■
of each size
250 x 16 mm staples, 500 x 25 mm staples,
■
250 x 40 mm staples

5. Intended use

The stapler is a pneumatically operated tool
designed for versatile use.
This equipment is designed for driving finishing
nails and staples into wood and similar
materials. Only use the types of nails/staples
described in the "Technical data" section or
illustrated on the information sign on the
magazine. Never use any other nails/staples.
Never use on hard surfaces such as stone,
metal, etc., either.
The equipment may only be used for the tasks it
is designed to handle. Any other use is deemed
to be a case of misuse. The user/operator and
not the manufacturer will be liable for any
damage or injuries of any kind caused as a
result of this.