Specifications - Makita PW5000C Bedienungsanleitung

ENGLISH (Original instructions)
1-1. Shaft lock
1-2. Cover
2-1. Slide switch
2-2. Cover
3-1. Speed adjusting dial

SPECIFICATIONS

• Due to our continuing programme of research and development, the specifications herein are subject to change without notice.
• Specifications may differ from country to country.
• Weight according to EPTA-Procedure 01/2003
Intended use
The tool is intended for surface work with natural stone.
Power supply
The tool should be connected only to a power supply of
the same voltage as indicated on the nameplate, and
can only be operated on single-phase AC supply. They
are double-insulated in accordance with European
Standard and can, therefore, also be used from sockets
without earth wire.
Noise
The typical A-weighted noise level determined according
to EN60745:
Sound pressure level (L
Sound power level (L
Uncertainty (K) : 3 dB(A)
Vibration
The vibration
determined according to EN60745:
Work mode : polishing
Vibration emission (a
Uncertainty (K) : 1.5 m/s
If the tool is used for other applications, the vibration
emission value may be different.
The declared vibration emission value has been
•
measured in accordance with the standard test
method and may be used for comparing one tool
with another.
The declared vibration emission value may also be
•
used in a preliminary assessment of exposure.
Downloaded from www.Manualslib.com
4-1. Lever
4-2. Open
4-3. Close
6-1. Abrasive disc
6-2. Pad
Model
Spindle thread
Pad diameter
Rated speed (n)/No load speed (n
Overall length
Net weight
Safety class
) : 85 dB(A)
pA
) : 96 dB(A)
WA
Wear ear protection
total value (tri-axial
2
) : 5.0 m/s
h,P
2
manuals search engine
Explanation of general view
)
0
ENE057-1
WARNING:
The vibration emission during actual use of the
•
power tool can differ from the declared emission
ENF002-1
value depending on the ways in which the tool is
used.
Be sure to identify safety measures to protect the
•
operator that are based on an estimation of
exposure in the actual conditions of use (taking
account of all parts of the operating cycle such as
the times when the tool is switched off and when it
ENG102-3
is running idle in addition to the trigger time).
For European countries only
EC Declaration of Conformity
We Makita
manufacturer declare that the following Makita
machine(s):
ENG209-3
Designation of Machine:
Stone Polisher
vector sum)
Model No./ Type: PW5000C,PW5000CH
are of series production and
Conforms to the following European Directives:
98/37/EC until 28th December 2009 and then with
2006/42/EC from 29th December 2009
And are manufactured in accordance with the following
standards or standardised documents:
ENG901-1
EN60745
The technical documentation is kept by our authorised
representative in Europe who is:
Makita International Europe Ltd,
Michigan, Drive, Tongwell,
Milton Keynes, MK15 8JD, England
3
6-3. Spindle
6-4. Cover
7-1. Cover
9-1. Exhaust vent
9-2. Inhalation vent
PW5000C,PW5000CH
M14
max. 125 mm
-1
2,000 - 4,400 min
313 mm
2.3 kg
/II
Corporation as the responsible
ENH101-13