Maintenance - Makita PW5000C Bedienungsanleitung

Never switch on the tool when it is in contact with
•
the workpiece, it may cause an injury to operator.
Never run the tool without the abrasive disc. You
•
may seriously damage the pad.
The maximum permitted pressure of water supply
•
is 7 bar.
Make sure that the cock is closed. Connect the hose to
the tool. Make sure that water comes out when the water
lever is opened.
Fig.8
Hold the tool firmly. Turn the tool on and then apply the
abrasive disc to the workpiece.
Apply slight pressure only. Excessive pressure will result
in poor performance and premature wear to abrasive
disc.

MAINTENANCE

CAUTION:
Always be sure that the tool is switched off and
•
unplugged before attempting to perform inspection
or maintenance.
Fig.9
The tool and its air vents have to be kept clean.
Regularly clean the tool's air vents or whenever the
vents start to become obstructed.
To maintain product SAFETY and RELIABILITY, repairs,
carbon brush inspection and replacement, any other
maintenance or adjustment should be performed by
Makita Authorized Service Centers, always using Makita
replacement parts.
ACCESSORIES
CAUTION:
These
•
recommended for use with your Makita tool
specified in this manual. The use of any other
accessories or attachments might present a risk of
injury to
attachment for its stated purpose.
If you need any assistance for more details regarding
these accessories, ask your local Makita Service Center.
Abrasive discs
•
Side grip
•
Downloaded from www.Manualslib.com
accessories or attachments
persons. Only use accessory or
manuals search engine
are
7