Testing The Protective Conductor Resistance (Rpe) - Benning PV 2 Bedienungsanleitung

- Press and hold the
- Press the
- Press the
ting.
Note:
Measuring lead resistances can be compensated by up to 10 Ohm.
8.2 Testing the protective conductor resistance (R
The PV generator must be isolated from the electric power supply! Neither the
positive nor the negative pole of the PV generator must be earthed!
If a voltage of > 30 V is applied to the test object, the determined voltage will
be displayed. If the measuring voltage at the probe tips exceeds 30 V, the R
measurement will be blocked! If the R
low-impedance voltage source might trip the built-in fuse of the BENNING PV 2!
and and connect the test object.
- Press the
- Press the
and and connect the test object.
- Press and hold the
- Press the
- Press the
12/ 2017
to store the setting.
or the to increase or decrease the value.
.
.
to store the measured value to the next storage location available.
to terminate the continuous measurement.
to store the measured value to the next storage location available.
and
measurement
)
PE
measurement is started below 30 V, a
PE
and .
and .
to store the set-
-
-
until the
PE
22