Operation; Maintenance; Manufacturer's Warranty - REMS Nano Betriebsanleitung

eng

3. Operation

Caution, danger of injury!
Keep hair, clothing and gloves away from the pipe rest (6) when a pipe is
rotating in the rollers. Loose clothing, jewellery or long hair could get caught
between the rotating pipe and the rollers.
3.1. Work Procedure
Mark the cut on the pipe. Pull the handle (7) far enough up so that the
pipe to be cut can be inserted into the pipe rest (6).
Caution: Support longer pipes (see 3.2). Press the touch switch (8)
and press the handle (7) against the pipe rest and cut the pipe.
Caution: The cut pipe sectors can fall to the floor immediately after
being cut!
3.2. Supporting the Material
Where applicable, longer pipes must be supported on both sides with
REMS Herkules (Art. No. 120100).

4. Maintenance

Pull out the mains plug before carrying out maintenance and repair work!
This work may only be performed by qualified personnel and instructed
persons.
4.1. Maintenance
Keep the rollers of the pipe rest clean. The REMS Nano gear run with
a life-long grease filling and does not need lubrication.
4.2. Inspection/Service
The motor has carbon brushes which are subject to wear. The electric
pipe cutting machine must therefore be inspected by an authorised
REMS service workshop from time to time. The carbon brushes cannot
be replaced so that the motor has to be changed when necessary.
See also 5. Behaviour in the Event of Faults.
5. Behaviour in the Event of Faults
5.1. Fault: Electric pipe cutting machine stops during operation.
Cause: ● Feed pressure too high.
● Blunt cutting wheel.
5.2. Fault: Pipe stops during cutting.
Cause: ● Pipe not round or not deburred on the outside.
● Idle rollers of the pipe rest soiled.
5.3. Fault: Pipe is not cut.
Cause: ● Unsuitable cutting wheel.
● Pipe not round or not deburred on the outside.
● Cutting wheel damaged.
5.4. Fault: Electric pipe cutting machine does not start.
Cause: ● Defective connecting cable.
● Defective device.
5.5. Fault:
Cutting wheel goes blunt or breaks off after 1 or 2 cuts.
Cause: ● Cutting in a notch in which the previous cutting wheel

6. Manufacturer's Warranty

The warranty period shall be 12 months from delivery of the new
product to the first user but shall be a maximum of 24 months after
delivery to the Dealer. The date of delivery shall be documented by
the submission of the original purchase documents, which must include
the date of purchase and the designation of the product. All functional
defects occurring within the warranty period, which clearly the conse-
quence of defects in production or materials, will be remedied free of
charge. The remedy of defects shall not extend or renew the guarantee
period for the product. Damage attributable to natural wear and tear,
incorrect treatment or misuse, failure to observe the operational instruc-
tions, unsuitable operating materials, excessive demand, use for
unauthorized purposes, interventions by the Customer or a third party
or other reasons, for which REMS is not responsible, shall be excluded
from the warranty.
Downloaded from www.Manualslib.com
was already blunted or damaged.
manuals search engine
Services under the warranty may only be provided by customer service
stations authorized for this purpose by REMS. Complaints will only be
accepted if the product is returned to a customer service station author-
ized by REMS without prior interference in an unassembled condition.
Replaced products and parts shall become the property of REMS.
The user shall be responsible for the cost of shipping and returning
the product.
The legal rights of users, in particular the right to claim damages from
the Dealer, shall not be affected. This manufacturer's warranty shall
apply only to new products purchased in the European Union, in Norway
or Switzerland.
eng