Connecting The Headphones To A Second Bluetooth ® Device; Clearing Paired Devices - Silvercrest SBKP 4 A1 Bedienungs- Und Sicherheitshinweise

connection is not restored within 5 minutes, the headphones will
switch off.
The headphones may be manually switched off by holding the
button
5
LED indicator
Connecting the headphones to
a second Bluetooth
The headphones may be connected to two Bluetooth
devices at the same time. If the headphones are already connected to
a device, follow the steps below to connect to the second device:
Activate multipoint mode by pressing and holding
for approx. 3 seconds. Acoustic signal sounds. The first communi-
cation device (mobile phone or computer) is disconnected.
Now connect to the second communication device via Bluetooth
with the headphones. Please refer to the notes in the instructions
for your communication device. Select the entry "SBKP 4 A1" from
the list of devices detected by your computer or mobile. The second
communication device is connected.
Briefly press
communication device is connected again. Now, both communica-
tion devices are connected to the headphones simultaneously.

Clearing paired devices

In paired mode (the LED indicator
every 5 seconds), press and hold
acoustic signal sounds.
The headphones is now in pairing mode. The LED indicator
flashes blue and white.
for 3 seconds until acoustic signal sounds and the
goes out.
7
®
button and acoustic signal sounds. The first
2
device
will briefly flash blue twice
7
button
2
communication
®
button
2
®
for 3 seconds and
7
GB/IE 37