Benelli BN125 Bedienungsanleitung Seite 109

Instrument and control functions
Turn signal indicator lights "
" "
Each indicator light will flash when its cor-
responding turn signal lights are flashing.
EN
Neutral indicator light "N"
This indicator light comes on when the
transmission is in the neutral position.
3
High beam indicator light "
This indicator light comes on when the
high beam of the headlight is switched
on.
Engine trouble warning light "
This warning light comes on if a problem
is detected in the engine or other vehicle
control system. If this occurs, have a Be-
nelli dealer check the on-board diagnostic
system.
The electrical circuit of the warning light
can be checked by turning the key to" ".
The warning light should come on initially
and then go off after some engine revolu-
tions. If the warning light does not come
on initially when the key is turned to" ",
or if the warning light remains on, have a
Benelli dealer check the vehicle.
Tachometer
" and
The tachometer shows the running tur-
nover of the engine so that the rider can
keep it within the ideal power range.
Transmission gear display
The transmission gear display shows the
selected gear.
This model is equipped with 5 gears.
"
Reserve fuel indicator
Comes on when approximately 1.5 litres
of fuel are left; in this case, fill up the tank
as soon as possible.
"
Fuel gauge
The digital fuel gauge shows the capacity
of the fuel tank. As the fuel level drops, the
lines on the gauge will become closer and
closer to the "E" reserve area.
Speedometer
Push the menu switch "SELECT" to enter
the setting mode "TOTAL KM".
Speedometers Indicates the vehicle's spe-
ed in km/h or mph. To pass from one to
the other, press the "SELECT" button.
Total/partial kilometre counter
The total kilometre counter shows the to-
tal distance covered in kilometres.
Set in the mode instrumentation "TRIP A /
TRIP B" with the "RESET" button.
The partial kilometre counter (TRIP A/TRIP
B) shows the distance covered since the
last reset in kilometres.
The partial kilometre counter can be used
to estimate the possible distance to cover
with a full tank of fuel. This information
may make it possible to schedule future
fuelling stops.
RESET/SELECT buttons
Buttons to set vehicle data.
Press the "RESET" button to see the partial
or total kilometres.
When viewing partial kilometres (TRIP A/
TRIP B), it is possible to reset them by
holding down the "RESET" button for 3
seconds.
3 - 4