Kettenbach Identium Heavy Gebrauchsinformation Seite 14

Warnings
Do not use Identium impression materials for two-step
®
putty-wash impression technique or temporary reliner.
Do not use Identium impression materials with other
®
elastomeric impression materials.
Cautions
Do not use after expiration date.
Do not leave any residual impression material in the sulcus
or oral cavity.
Do not swallow impression material! If swallowed: Consult a
medical doctor if problems arise or persist.
Avoid contact with the eyes. If there is accidental contact with
the eyes: Rinse immediately and thoroughly with an eye wash
or water. Consult a medical doctor if problems arise or persist.
These products do not normally cause allergic reactions;
however, for sensitive persons, an allergic reaction to the
products cannot be ruled out.
Use of products containing active sulfur, aluminium chlo-
ride or nitrogen compounds (retraction cords containing fer-
ric sulfate, polysulfide impression materials, etc.) in conjunc-
tion with this product will interfere with the setting reaction of
the Vinylsiloxanether material. Use of these materials requires
®
14
the area to be rinsed thoroughly to remove all residue. Avoid
contact with latex gloves.
When taking impressions of areas with severe undercuts and
wide interdental spaces, standard blocking-out techniques
must be used.
When using a custom impression tray, ensure that sufficient
space remains between the side of the tray and the teeth/jaw.
Do not allow the material to enter the sewer or water system
to avoid environmental hazard.
Avoid contact with clothing, as the material cannot be removed
by dry cleaning.
Note
To ensure optimal impressions, the temperature of the
material should not deviate from 23°C (74°F) before apply-
ing. Otherwise, working and setting times will be affected.
Impression Tray: Preparation and Adhesives
In principle, all common impression trays can be used if
a relevant dynamic pressure is guaranteed. When reten-
tion is not sufficient, to ensure a strong bond to the impres-
sion material, brush the impression tray with a thin film of
Identium Adhesive prior to loading the tray with impression
®
material. Allow to dry as per instructions for use and cover with
a sufficient amount of impression material.
37453 5120
/
Identium
®