Operation - Hama EWS-200 Bedienungsanleitung

6. Operation

Note – Input
Hold down the UP button (23) or the DOWN/MEM button
(24) to select the values faster.
6.1. Connection to the measuring station
• After you insert the batteries, the base station automatically
searches for a connection to the measuring station and
performs initial setup.
Note
• Initial setup takes approx. 3 minutes.
• During connection, the wireless symbol on the measuring
station will ash (17).
• Do not press any buttons during setup. Otherwise, values
may not be transmitted correctly and there is a risk of
value errors and inaccuracies.
• The setup process is completed when the indoor (5, 16)
and outdoor (8, 18) measurement data is displayed.
• If the base station still does not receive a signal from the
measuring station, press and hold the CH-button (25) for
approx. 3 seconds to start the manual search for the signal.
6.2. Selecting the channel/other measuring stations
Note
You can install two more measuring stations in addition to
the included measuring station. Ensure that the base and
measuring stations are set to the same channel. Visit www.
hama.com for suitable measuring stations.
• Press the CH-button (25) repeatedly to set the channel to
that set on the respective measuring station – see 4.1.
Measuring station.
1, 2, 3 (7) is displayed.
• Select CH1 if you are only using the measuring station
supplied.
• The base station now shows the data measured (8, 18) on the
selected measuring station (7).
6.3. Basic and manual settings
Automatic setting using the DCF signal
• After the rst time the base station is switched on and
successful transmission is established between the base
station and the measuring station, the clock will automatically
search for a DCF signal. During the search, the wireless
symbol (9) will ash.
Display
Display ashing
4
Searching for the DCF signal
Active
Displayed continuously
Not displayed
• If the station still does not receive a signal, press and hold
the UP button (23) for approx. 3 seconds to start the manual
search for the DCF signal. The wireless symbol (9) will start
to ash.
Note – Time settings
• The search process takes about 7 minutes. If it fails, the
search ends.The radio symbol (9) disappears.
• In the meantime, however, you can set the time and the
date manually.
• The clock automatically continues to search for the DCF
signal on a daily basis (1:00, 2:00, 3:00, 4:00 and 5:00
a.m.). If the signal is received successfully, the manually set
time and date are overwritten.
Note – Summer time
• The clock automatically switches to summer time.
(3) appears on the display as long as summer time is
activated.
• Press and hold the UP button (23) for approx. 3 seconds to
stop the manual search.
(Manual) settings
• Press and hold the UP button (23) for approx.
3 seconds to stop the search for the DCF signal. The wireless
symbol (9) goes out and you can set the time manually.
• Press and hold the MODE button (22) for approx. 3 seconds
to make the following settings one after the other:
• Year (10)
• Month (12)
• Day (11)
• Weekday (13)
• Time zone (10)
• 12/24 hour format (10)
• Hours (10)
Alarm time
• Minutes (10)
• Temperature unit °C/°F (5.8)
• To select the individual values, press the UP button (23) or
the DOWN/MEM button (24) and con rm each selection by
pressing the MODE button (22).
• If you do not make an entry for 30 seconds, the device
automatically exits the settings mode and the settings you
made are saved.
Successful – signal is being
received
Deactivated