Hama EWS-200 Bedienungsanleitung Seite 7

Note – Time zone
• The DCF signal can be received over long distances, but
always transmits the current Central European Time in
Germany. Make sure you account for the time difference in
countries with another time zone.
• If you are in Moscow, the time is 3 hours later than in
Germany. This means that you should set +3 for the
time zone. The clock then automatically sets the time to
3 hours after the DCF signal received or relative to the
manually set time.
Note – Weekday
You can choose from German (GE), English (EN), Danish
(DA), Dutch (NE), Italian (IT), Spanish (SP) or French (FR)
for the weekday display.
Celsius/Fahrenheit
• Follow the steps described for (Manual) settings to
switch between °C and °F on the temperature display.
• If the temperature is outside of the measuring range, LL.L
(lower than minimum temperature) or HH.H (higher than
maximum temperature) will appear on the temperature
display.
Alarm
• Repeatedly press the MODE button (22) to access alarm
mode.
• AL is displayed accordingly in the seconds display.
• Press and hold the MODE button (22) for approx. 3 seconds
to set the signal time of the alarm displayed. The hours
display begins to ash.
• Set the following information in the order listed:
• Hours
• Minutes
• To select individual values, press the UP button (23) or the
DOWN/MEM button (24) and con rm each selection by
pressing the MODE button (22).
• If you do not make an entry for 30 seconds, the device
automatically exits the settings mode and the settings you
made are saved.
• In the alarm mode (AL) display, press the UP button (23) or
the DOWN/MEM button (24) to activate or deactivate the
alarm. The alarm symbol (1) will appear/not appear.
• If the alarm is triggered, the alarm symbol (1) will begin to
ash and an alarm will sound.
• Press any button (except the SNZ/LIGHT button (27)) to
stop the alarm. Otherwise, it will stop automatically after
2 minutes.
Note – Snooze function
• While the alarm signal is sounding, press the SNZ/LIGHT
button (27) to activate the snooze function. Zz begins to
ash on the display. The alarm signal will be stopped for 5
minutes, after which it will sound again.
• Press any button (except the SNZ/LIGHT button (27)) to
stop the snooze function and the alarm.
6.4. Weather forecast/ atmospheric pressure history
• Based on changes in the atmospheric pressure and the data
saved, the base station is able to make weather forecasts for
the next 12 to 24 hours.
Note – Weather forecast
The weather forecast function is not available during the
rst few hours of operation because it requires data that is
collected during operation.
• The weather forecast and the current weather are indicated
by ve different symbols (4):
Symbol (2)
• The weather station indicates a trend as to how the values
for the outdoor temperature (8) and room temperature (5) are
likely to develop over the next few hours.
Weather
Sunny
Slightly cloudy
Cloudy
Rainy
5