Initial Operation - Scheppach BAP350 Original Bedienungsanleitung

• There is a risk of electrocution.

9. Initial operation

m IMPORTANT!
You must fully assemble the appliance
before using it for the first time!
Fitting the pump to a rain barrel
Use the attachment hook to fit the pump
to the rain barrel (1).
Adjustment of the float switch
• The float switch must be attached so
that the switching point ON level and
the switching point OFF level can be
reached easily and with little expendi-
ture of energy.
• Check this by placing the pump into a
vessel filled with water and lift the float
switch carefully by hand and then low-
er it again. In this case, you can see
whether the pump switches on and off.
• Also ensure that the separation dis-
tance between the float switch head
and the float switch latching mecha-
nism is not too small. In the case of a
separation distance which is too small,
trouble-free
guaranteed.
• During the adjustment of the float
switch, ensure that the float switch
does not contact the floor before the
pump switches off.
• Attention! Risk of running dry and dam-
age to the device.
 www.scheppach.com /  service@scheppach.com /  +(49)-08223-4002-99 /  +(49)-08223-4002-58
functioning cannot
Electrical connection
The electrical motor installed is connect-
ed and ready for operation. The connec-
tion complies with the applicable VDE
and DIN provisions.
Damaged electrical connection cable
The insulation on electrical connection
cables is often damaged.
This may have the following causes:
• Passage points, where connection ca-
bles are passed through windows or
doors.
• Kinks where the connection cable has
been improperly fastened or routed.
• Places where the connection cables
have been cut due to being driven over.
• Insulation damage due to being ripped
out of the wall outlet.
• Cracks due to the insulation ageing.
Such damaged electrical connection ca-
bles must not be used and are life-threat-
ening due to the insulation damage.
Check the electrical connection cables
be for damage regularly. Make sure that the
connection cable does not hang on the
power network during the inspection.
Electrical connection cables must comply
with the applicable VDE and DIN provi-
sions. Only use connection cables with
the marking „H05RN-F".
GB | 25