Cleaning, Maintenance And Storage - Scheppach BAP350 Original Bedienungsanleitung

10. Cleaning,
and storage
Cleaning
Attention!
Always unplug the power cord before
cleaning.
General cleaning instructions
• In case of transport for utilization in
different locations, the pump must be
cleaned with clear water after every
use.
• In case of stationary installation, the
function of the float switch (3) is to be
checked regularly (at the latest every
three months).
• With a water jet, remove fluff and fibrous
particles which are possibly present in
the pump casing
• Regularly remove sludge from the pit
base (at the latest every 3 months) and
also clean the shaft walls
• Clean precipitation from the float switch
with clear water,
• In the case of a long period of non-use,
the pump must be thoroughly cleaned
after the last use and before the new
use, since difficulties in start-up can
arise due to precipitation and residues.
Cleaning the filter (Fig. 7 - 9)
In order to protect the equipment and the
impeller from severe soiling, an addition-
al filter has been installed in the bottom
intake cage. Please proceed as follows
when cleaning the filter:
1. Gently press the lateral tab in the di-
rection of the arrow until the intake
cage (5) can be disconnected from the
pump.
26 | GB
 www.scheppach.com /  service@scheppach.com /  +(49)-08223-4002-99 /  +(49)-08223-4002-58
maintenance
2. Remove the filter and wash it out un-
der running water.
3. Now insert the filter back into the in-
take cage and reconnect the intake
cage to the equipment.
Store the device and its accessories in a
dark, dry and frost-proof place that is in-
accessible to children. The optimum stor-
age temperature is between 5 and 30˚C.
Cover the electrical tool in order to pro-
tect it from dust and moisture.Store the
operating manual with the electrical tool.
Maintenance
The pump is largely maintenance-free.
However, we recommend regular inspec-
tions and care for a long service life.
Connections and repairs
Connections and repairs of electrical
equipment may only be carried out by an
electrician.
Please provide the following informa-
tion in the event of any enquiries:
• Type of current for the motor
• Machine data - type plate
• Motor data - type plate
Service information
Please note that the following parts of
this product are subject to normal or nat-
ural wear and that the following parts are
therefore also required for use as con-
sumables.
Wear parts*: Seals
* Not necessarily included in the scope of
delivery!