Schüco IPE 030 CN 05 Kurzanleitung Seite 80

Commissioning
76
6. Set the date and time centrally for all connected units.
Select date with . Change the selected number with
the next number with
Confirm the date with
Confirm the time with
NOTE
Please note that time settings should only be made with caution, as they directly af-
fect data logging. For example, if you set the time back by 1 hour, then the existing
data will be overwritten.
7. Automatic or manual device search
The IDs for the slaves can be allocated automatically or manually.
8. CAN network list is set up.
If the search is set to manual, the IDs must be confirmed at each slave before
commissioning of the master is continued.
Confirm with .
NOTE
Depending on the side of the network, it may take a moment until the master has
found all slaves and added them to the list.
9. Set password centrally for all connected units. Select Password with
The default password is:
******** (8 asterisks)
A new password can be set with
Confirm the password with
NOTE
Please note:
Only digits between 0 – 9 and letters between a – z and A – Z are permitted.
The password always has 8 characters. If the password you entered has less than
8 characters, the remaining characters will be filled with "*".
Example:
The password you have chosen is "Solar". This password has 5 characters. The sys-
tem automatically adds three "*", so that the password becomes "Solar***".
/ .
and set the time accordingly.
.
/ / /
.
/ and jump to
.
as an option.
IPE 030 - 033 CN 05