Tools Required; Parts Included - Vision Fitness T600E Bedienungsanleitung

ASSEMBLY
UNPACKING
Unpack the equipment where you will be using it. Place the carton
on a level flat surface. It is recommended that you place a protective
covering on your floor. Never open box when it is on its side.
IMPORTANT NOTES
During each assembly step, ensure that ALL nuts and
bolts are in place and partially threaded.
Several parts have been pre-lubricated to aid in assembly
and usage. Please do not wipe this off. If you have difficulty, a
light application of lithium grease is recommended.
WARNING!
There are several areas during the assembly process that special attention must be
paid. It is very important to follow the assembly instructions correctly and to make
sure all parts are firmly tightened. If the assembly instructions are not followed
correctly, the equipment could have parts that are not tightened and will seem
loose and may cause irritating noises. To prevent damage to the equipment, the
assembly instructions must be reviewed and corrective actions should be taken.
NEED HELP?
If you have questions or if there are any missing parts, contact Customer
Tech Support. Visit world.visionfitness.com for contact information.

TOOLS REQUIRED:

8mm T-Wrench
F
8mm Allen Wrench
F
6mm Allen Wrench
F
Phillips Screwdriver
F

PARTS INCLUDED:

1 Base Frame
F
1 Console base set
F
1 Console Assembly
F
2 Console Masts
F
2 Handlebars
F
1 Power Cord
F
1 Hardware Kit
F
5