Proper Use; Technical Data - EINHELL 43.405.15 Originalbetriebsanleitung

Danger!
The equipment and packaging material are machine is used in commercial, trade or industrial not
toys. Do not let children play with plastic businesses or for equivalent purposes.
bags, foils or small parts. There is a danger
of swallowing or suff ocating!
•
Saw blade guard / splitter
•
Push stick
•
Parallel stop
•
Hand wheel
•
Crank arm
•
Rubber foot (4x)
•
Cross stop
•
Screw for parallel stop (2x)
•
Stop rail for parallel stop
•
Knurled screw (2x)
•
Leg (4x)
•
Cross strut (4x)
•
Locking screw for table width extension (4x)
•
Locking screw for table length extension (2x)
•
Table width extension (left)
•
Table width extension (right)
•
Table length extension
•
Additional leg (2x)
•
Wrench, size 10/13 mm
•
Wrench, size 10 mm
•
Hex screw (8x)
•
Washer, large (8x)
•
Lock bolt (8x)
•
Washer, small (12x)
•
Spring washer (8x)
•
Nut (12x)
•
Recessed head screw (6x)
•
Screw with washer and spring washer (4x)
•
Original operating instructions
•
Safety information

3. Proper use

The bench-type circular saw is designed for the
slitting and cross-cutting (only with the cross
stop) of all types of timber commensurate with
the machine's size. The equipment is not to be
used for cutting any type of round wood.
Anl_TC_TS_2225_U_SPK9.indb 29
GB
applications. Our warranty will be voided if the
The equipment is to be used only for its
prescribed purpose. Any other use is deemed to
be a case of misuse. The user / operator and not
the manufacturer will be liable for any damage or
injuries of any kind caused as a result of this.
Please note that our equipment has not been
designed for use in commercial, trade or
industrial The equipment is to be operated only
with suitable saw blades (saw blades made of
HM or CV) It is prohibited to use any type of HSS
saw blade and cutting-off wheel.
To use the equipment properly you must also
observe the safety information, the assembly
instructions and the operating instructions to be
found in this manual.
All persons who use and service the equipment
have to be acquainted with these operating
instructions and must be informed about the
equipment's potential hazards. It is also
imperative to observe the accident prevention
regulations in force in your area. The same
applies for the general rules of health and safety
at work. The manufacturer will not be liable for
any changes made to the equipment nor for any
damage resulting from such changes. Even
when the equipment is used as prescribed it is
still impossible to eliminate certain residual risk
factors. The following hazards may arise in
connection with the machine's construction and
design:
•
Contact with the saw blade in the uncovered
saw zone.
•
Reaching into the running saw blade (cut
injuries).
•
Kick-back of workpieces and parts of
workpieces.
•
Saw blade fracturing.
•
Catapulting of faulty carbide tips from the
saw blade.
•
Damage to hearing if essential ear-muffs are
not used.
•
Harmful emissions of wood dust when used
in closed rooms.

4. Technical data

AC motor ..................................220-240V ~
50Hz Power P ..................S1 1800 W · S6 25%
29.10.2019 11:29:09