Specifications; Stihl Fsa 60 R Brushcutter; Stihl Ak Battery; Charger Stihl Al 101 - Stihl FSA 60 R Gebrauchsanleitung

English

20 Specifications

20.1 STIHL FSA 60 R Brushcutter

– Approved battery: STIHL AK
– Weight without battery, cutting attachment and guard:
3.3 kg
– Length without cutting attachment: 1680 mm
The running time is shown at www.stihl.com/battery-life.

20.2 STIHL AK Battery

– Battery technology: Lithium-ion
– Voltage: 36 V
– Capacity in Ah: see rating label
– Energy content in Wh: see rating label
– Weight in kg: see rating label
– Permissible temperature range for operation and storage:
-10°C to +50°C

20.3 Charger STIHL AL 101

– Rated voltage: see rating plate
– Frequency: see rating plate
– Rated power: see rating plate
– Charging current: see rating plate
– Permissible temperature range for use and storage:
+ 5 °C to + 40 °C
The charging times are indicated at
www.stihl.com/charging-times.
56

20.4 Extension Cords

If an extension cord is used, the cross sectional area of its
conductors must meet the following minimum requirements
– depending on the line voltage and length of the extension
cord:
If rated voltage on the rating label is 220V to 240V:
– Cord length up to 20 m: AWG 15 / 1.5 mm²
– Cord length 20 m up to 50 m: AWG 13 / 2.5 mm²
If rated voltage on the rating label is 100V to 127V:
– Cord length up to 10 m: AWG 14 / 2.0 mm²
– Cord length 10 m up to 30 m: AWG 12 / 3.5 mm²

20.5 Sound Values and Vibration Values

K-value (uncertainty) for sound pressure levels is 2 dB(A).
K-value for sound power levels is 2 dB(A). K-value for
vibration level is 2 m/s².
STIHL recommends wearing ear defenders.
– Sound pressure level L
pA
EN 50636-2-91: 81 dB(A)
– Sound power level L
wA
EN 50636-2-91: 94 dB(A)
– Vibration level a measured as specified in EN 50636-2-
hv
91
– Control handle: 2.0 m/s².
– Loop handle: 3.7 m/s².
The vibration levels indicated were measured according to a
standardized test method and can be used as a basis for
comparing electric power tools. The vibration levels actually
occurring may vary from the values indicated, depending on
the type of application. The vibration levels indicated can be
used for an initial estimate of the vibration stress. The actual
vibration stress has to be estimated. The times when the
power tool is switched off and the times when it is switched
on but running under no load can be taken into account in
the estimate.
20 Specifications
measured as specified in
measured as specified in
0458-832-9821-A