Scale Zero Function; Tare Function; Limitation Of The Tare Functions; Overload Message - Scale House AWM Serie Bedienungshandbuch

6.2 SCALE ZERO FUNCTION

You can press the ZERO key at any time to set the zero point from which all other weighing and counting is measured,
within +/- 2% of power up zero. This will usually only be necessary when the platform is empty. When the zero point is
obtained the display will show the indicator for zero.
The scale has an automatic rezeroing function to account for minor drifting or accumulation of material on the platform
(see step "AZ", section 7.1). However you may need to press the ZERO key to rezero the scale if small amounts of
weight are shown when the platform is empty.

6.3 TARE FUNCTION

Zero the scale by pressing the ZERO key if necessary. The zero symbol will be on.
Place a container on the platform, a value for its weight will be displayed.
Press the TARE key to tare the scale when the "stable" is light. The weight that was displayed is stored as the tare
value and that value is subtracted from the display, leaving zero on the display. The "NET" indicator will be on. As
product is added only the weight of the product will be shown. The scale could be tared a second time if another type
of product was to be added to the first one. Again only the weight that is added after taring will be displayed.
When the container is removed a negative value will be shown.
To remove the tare, unload the scale and press again TARE.

6.3.1 LIMITATION OF THE TARE FUNCTIONS

With approved instrument, it is not possible to execute the TARE function several consecutive times; one has first to
cancel the executed tare, by unloading the scale and pressing TARE key, then execute again the function.

6.4 OVERLOAD MESSAGE

Please do not add item that is over the maximum capacity. When reading "- - - - - -" and hear beeping sound, remove
the item on the platter to avoid damage to the load cell.

6.5 TOTALISATION OF THE WEIGHT

The scale can be set to accumulate manually the weight on the scale by pressing the M+ key (see step "AU", chapter
7.1).
The weight displayed will be stored in memory when the M+ key is pressed and the weight is stable.
The display will show "ACC 1" and then the total in memory for 2 seconds before returning to normal.
Remove the weight, allowing the scale to return to zero and put a second weight on. Press the M+ key, the display will
show " ACC 2" and then the new total.
Continue until all weights have been added.
To view the totals in memory press M+ key when current scale in zero status (Zero indicator on)
To clear the accumulated total weight, press the F key when show total values.
To exit form the visualization of the total values press M+ key.
NOTE:
- The totalisation functions with a minimum weight of 20d.
- The maximum number of totalisations is 999 while the maximum total value which may be accumulated is
999999.
Once reached these limits, one should clear the total; by pressing M+ the message "AdErr" will appear on the
display.
- The total values will be cleared when it's turned off.
9