Operation Modes; Function Of The Keys; Zero And Tare Operations - Scale House OCSF Series Benutzerhandbuch

II. OPERATION MODES
II.1 FUNCTION OF THE KEYS
a) On&Off/Tare/Zero: press for about 3 seconds in order to turn the scale on and off. In weighing, press this key for the

Zero and Tare operations.

b) Clear/CAL: press, for cancelling the accumulated total. If press at length a length permit to enter in programming
menu.
c) M+: press to accumulate the weight (the relative arrow turned on); for shows the total press when the scale is unload.
In programming, this key can be used as "exit".
d) Set/Div.: press for change the division of the scale (selectable divisions depending on the version, Ref. Par.I.1).
NOTE:The division set is saved even though the instrument has been switched off. In programming, this key be used
for modify a parameter.
e) Menu/Hold: In weighing, press to freeze the weight shown on the display (the relative arrow turned on). By pressing
again this key, the display unlocks. When the display shows the accumulated data, the Menu/Hold key does not
work. Press this key for enter in the menu for set unit of measure and the backlight and switch-off function (see par.
IV, V, VI).
II.2 ZERO AND TARE OPERATIONS
a) Instantaneous tare
When the suspended weight is stable, press the [On&Off/Tare/Zero] key: if the weight reenters the zero range (4% F.S.)
configured by the user, the crane scale clears the weight and turned on the arrow on the display which indicate ZERO
(zero function); if, on the other hand, the weight is greater than the zero range, the crane scale executes a tare and the
arrow on the display which indicate TARE (tare function).
3