Inhaltsverzeichnis
Werbung
TABLE 1 - TABLEAU 1 - TABELLE 1 - TABLA 1 - TAVOLA 1
10
43
10
05
19
11
09
08
15
04
03
03
04
01
05
04
44
39
4.1) Using the battery charger
Carefully follow the instructions in the battery charger manual.
4.2) General information on how to use batteries
In order to use the batteries correctly, please follow these rules:
– Use the battery until the automatic residual energy display still has 1-2 LEDs showing:
this means the battery is almost completely discharged and no loss in the life of the
battery has been caused.
– Be particularly careful when charging a new battery the fi rst 2-3 times in order to be
certain of maximising the available energy level.
– Allow the battery to cool down to ambient temperature prior to recharging.
– Rest the battery charger for at least 15 minutes between charges.
5. MAINTENANCE
The tool is robust, completely sealed and requires very little daily maintenance.
Compliance with the following points should help to maintain the optimum performance
of the tool:
5.1) Thorough cleaning
Dust, sand and dirt are a danger for any hydraulic device.
Every day, after use, the tool must be wiped with a clean cloth taking care to remove any
residue, especially close to pivots and moveable parts.
6. RETURN TO Cembre FOR OVERHAUL
In the case of a breakdown contact our Area Agent who will advise you on the problem
and give you the necessary instructions on how to dispatch the tool to our nearest service
Centre; if possible, attach a copy of the Test Certifi cate supplied by Cembre together
with the tool or, if no other references are available, indicate the approximate purchase
date and the tool serial number.
8
ENGLISH
5.2) Storage
When not in use, the tool should be stored
and transported in the plastic case, to prevent
damage. The case is suitable for storing the
tool and the accessories.
Plastic case: VAL P9-C, size 543x412x130 mm,
(21.4x16.2x5.1 inches) weighs 2,2 kg (4.8 lbs) is
suitable for storing the tool, the accessories and
up to 8 sets of semi-circular slotted dies .
Is available VAL 130 steel case: size 360x280x48
mm (14.17x11x1.89 in.), weight 3 kg (6.62 lbs),
for storage of the accessories for crimping
aluminium connectors.
Werbung
Inhaltsverzeichnis
