Inhaltsverzeichnis
Werbung
ENGLISH
– To insert the adaptor AC130-P (91), press the die release pin (04).
Insert the adaptor into the seat of the ram (14), until secured by the retaining pin (02).
To facilitate this operation, an advancement of 3÷4 mm (0.11 - 0.16 in.) of the ram (14)
is suggested.
To remove the adaptor, press the die release pin (04) and slide the adaptor from the
ram (14).
3.7.4) Dies, indentors, pre-rounding dies - fi tting and removal
– The containing die (96) and upper pre-rounding die (95): are located in the adaptor
AU130-... (98) by grooves in the upper face.
– The lower pre-rounding die (94): is inserted or removed from the adaptor AC130-P
(91), by pulling the release button (92).
– The indentor PS130.../E (93): is inserted into the seat on the ram (14).
3.8) Battery status
After releasing the operating button, the residual battery
capacity is automatically displayed for 5 seconds on the
indicator (15).
The number of LEDs illuminated indicates the residual capacity:
10 LEDs illuminated: Fully charged
5 LEDs illuminated: 50 % capacity
1 LED illuminated: Minimum charge
When replacing the battery, press the two points marked with the word "PUSH" at the
same time, remove the fl at battery from its housing and insert the new one.
4. WARNING
Before starting work on electrical equipment, please ensure that either there are no live
parts in the immediate working area or that precautions are taken for working near live
parts in accordance with EN50110-1.
D
O NOT USE THIS TOOL ON OR NEAR ENERGIZED CONDUCTORS WITHOUT PROPER
PERSONAL PROTECTIVE EQUIPMENT
RESULT IN SEVERE INJURY OR DEATH
T
HE TOOL IS UNSUITABLE FOR CONTINUOUS USE AND SHOULD BE ALLOWED TO
COOL DOWN FOLLOWING UNINTERRUPTED
,
INSTANCE
HAVING EXHAUSTED A FULLY CHARGED BATTERY IN ONE SESSION
BATTERY REPLACEMENT FOR A FEW MINUTES
O
BSERVE RECOMMENDED REST PERIODS ALSO WHEN USING AN EXTERNAL POWER
.
SUPPLY
P
ROTECT THE TOOL FROM RAIN AND MOISTURE
. E
-
AND BATTERY
LECTRO
HYDRAULIC TOOLS SHOULD NOT BE OPERATED IN POURING
.
RAIN OR UNDER WATER
(Ref. to Fig. 5)
%
15
.
FAILURE TO OBSERVE THIS WARNING COULD
.
,
SUCCESSIVE CRIMPING OPERATIONS
,
.
. W
ATER WILL DAMAGE THE TOOL
7
;
FOR
DELAY
17
40
31
18
20
Serial number of tool
31
Numéro de série de l'outil
Seriennummer des Werkzeuges
05
Número de serie de la herramienta
Numero di matricola dell'utensile
32
33
13
06
EXP0916 Rev. 0 05-09-2006
See TABLE 2
Voir TABLEAU 2
Siehe TABELLE 2
Ver TABLA 2
Vedere TAVOLA 2
Werbung
Inhaltsverzeichnis
