Installation And Electrical Connection - Novy Domino 300 Gebrauchsanweisung

41902042GB.fm Page 12 Wednesday, June 22, 2011 10:28 AM
injury to persons or animals and for damage to
property resulting from failure to observe the
regulations provided in this chapter.
Electrical connections
• Hob electrical connection must be made before
• Electrical connection must be carried out in compliance
• Make sure that the voltage indicated on the rating plate
• Regulations require that the appliance is earthed: use
• For electrical connection, use an H05 RR-F type cable as
Connecting to the terminal board
Connect the yellow/green earth wire to the terminal with
the symbol
wires.
1. Remove the terminal block cover (A), undoing the
2. Strip approx. 70 mm of sheath from the power supply
3. Strip approx. 10 mm of sheath from the wires. Insert
4. Secure the power cable with the cable clamp.
5. Close the cover (C) and screw it on the terminal block
DOMINO
Downloaded from www.Manualslib.com

INSTALLATION and ELECTRICAL CONNECTION

Warning! Installation must be carried out by
a qualified electrician who is fully aware of
current safety and installation regulations.
The manufacturer declines all liability for
connecting the appliance to the electricity supply.
with the regulations of the local electric utility company.
on the underside of the appliance corresponds to the
domestic power supply voltage.
conductors (including the earth conductor) of the
appropriate size only.
specified in the table "
Power supply voltage
. This wire must be longer than the other
screw and inserting the cover in the terminal block
hinge (B).
cable.
the power supply cable into the cable clamp and
connect the wires to the terminal board as indicated in
the diagram next to the terminal board itself.
with the removed screw - point (1).
Each time the cooktop is connected to the mains it
carries out an automatic check which lasts several
seconds.
manuals search engine
Warning!The power supply cable must be
long enough to allow the hob to be removed
from the worktop and must be positioned
so as to avoid damage or overheating
caused by contact with the base of the hob itself. Do
not use extension leads.
Power supply voltage
Wires
230V ~ +
230-240V ~ +
230V 3 ~ +
400V 3N ~ +
400V 2N ~ +
If the hob already has a power cable, follow the
".
instructions given on the label attached to the
cable.
Connect the appliance to the electricity supply by
means of an all-pole disconnect switch with minimum
contact gap of 3 mm.
A
C
77X35
400V 3N ~
400V 2N ~
12
Amount x size
3 X 4 mm (3X2.5 mm Domino)
2 2
3 X 4 mm (Australia only)
2
(3X2.5 mm Domino)
2
4 X 1.5 mm
2
5 X 1.5 mm 2
4 x 1.5 mm
2
B
230-240V~FOR AU ONLY
230V~FOR UK ONLY
230V ~
230V 3~ 400V 2N~
ONLY FOR BELGIUM FOR NL ONLY