Care And Maintenance; Troubleshooting Guide; After-Sales Service - Novy Domino 300 Gebrauchsanweisung

41902042GB.fm Page 16 Wednesday, June 22, 2011 10:28 AM

Care and maintenance

Clean the hob after each use in order to avoid damaging
the surface and to prevent the formation of baked-on
deposits which are difficult to remove. Before cleaning,
make sure the cooking zones are switched off and that the
residual heat indicator ("H") is not displayed.

Troubleshooting Guide

• Before contacting After-sales Service:
• read and follow the instructions given in the section
• Connect the hob to the electricity supply and check that
emits an acoustic signal
F12, F21, F25, F36, F37,
F40, F47, F56, F58, F60

After-sales Service

Before contacting After-sales Service:
• Try to solve the problem (see "
• Switch the appliance off, wait 30 seconds then switch it
If after the above checks the fault persists, contact the
nearest After-sales Service.
Downloaded from www.Manualslib.com
MAINTENANCE
• Never clean the hob with a steam cleaner!
• Periodically check for dust under the
appliance, near the cooling air inlet or the
outlet openings. This could hinder the
ventilation and cooling of the electronic
module and decrease the effectiveness of
the hob.
" ".
Operating instructions
the supply has not been shut off.
ERROR CODE DESCRIPTION
The hob switches off
and after 30 seconds Continuous pressure on
control panel area
every 4 seconds
The control panel switches off
C81, C82 because of excessively high
temperatures
The connection voltage is
F42 or F43
wrong
Warning!
If you are unable to turn the glass-ceramic hob off after using it, disconnect it immediately from the
power supply.
Troubleshooting Guide
on again. to see if the fault persists.
manuals search engine
To clean the hob, proceed as follows:
1. use a soft clean cloth, absorbent kitchen wipes or a
proprietary cleaner for glass ceramic hobs. Do not use
abrasive sponges and/or metal scouring pads.
2. Food spills should be cleaned off before they bake
onto the glass ceramic surface. Sugar and foods with a
high sugar content damage the glass ceramic surface
and must be immediately removed using a scraper for
glass. Glass scrapers must be handled with care.
3. Remove any stubborn food residues with a scraper or
proprietary detergents.
4. Salt, sugar and sand can scratch the glass ceramic hob:
clean up any such spills on the hob immediately.
• Clean the hob and dry it thoroughly.
• If, when the hob is switched on, alphanumeric codes
appear on the display, consult the following table for
instructions.
POSSIBLE CAUSES
Water or utensils on control panel
The internal temperature of
electronic parts is too high
The sensor detects a discrepancy
between the appliance voltage and
that of the mains supply
Call the After-Sales Service and specify the error code
Always provide:
"). • a brief description of the fault;
• the exact type and model;
• the service number (number after the word Service on
the rating plate) is located on the underside of the
cooktop or on the warranty booklet;
• your complete address and phone number.
If any repairs are required, please contact an authorized
After-sales Service as indicated in the warranty.
Warning! Failure to comply with these
instructions may compromise the safety and
quality of the product.
16
REMEDY
Clean the control panel
Wait for the hob to cool down
before using it again
Disconnect the hob from the
mains and check the electrical
connection