Troubleshooting - Scheppach DS920 Original Bedienungsanleitung

13. Troubleshooting

Supposed malfunctions, errors or damages are often caused by events which can be remedied by the operator. There-
fore check the power tool on the basis of the following table before you contact a specialist. Many malfunctions may
thus be remedied.
Problem Possible cause
Power tool does not Power supply interrupted
start
Power cord or plug defective
Other electrical defect of the power
tool
Power tool does Extension cord too long and/or cross-
not operate with full section too small
power
Power supply (e.g. generator) voltage
too low
Poor operation Power tool worn out
results
Grinding plate worn out
Considerable dust Brush edge worn out
formation
Dust extraction not connected /
switched on
26 | GB
 www.scheppach.com /  service@scheppach.com /  +(49)-08223-4002-99 /  +(49)-08223-4002-58
Approach
Check power supply by connecting another power
tool
Have an electrician check the tool
Have an electrician check the tool
Use extension cord with permissible length and/or
adequate cross-section
Connect power tool to an appropriate power supply
Replace insertion tool
Have grinding plate replaced
Have brush edge replaced
Connect / switch dust extraction