Operating Modes - Baumer NE134 Betriebsanleitung

Line 51
Line 52
Line 53
Line 54
Step preset The counter counts to the next preset after having reached a preset.
P1 trailing preset The entry of preset P1 corresponds to the interval between the
Baud rate
0 * 4800 Baud
1 2400 Baud
2 1200 Baud
3 600 Baud
Parity
0 * Even parity
1 Odd parity
2 No parity
Stop bits
0 * 1 Stop bit
1 2 Stop bits
Address
0 * from
99 to
The dash line indicates the end of the third programming field.
By pushing or
of the first programming field. Programming can be shut down at any
time by pushing the keys
5.1

Operating modes

The following paragraphs describe the operating modes.
The presets are always handled in the sequence P1, P2. You can
select the preset of your choice. An automatic reset to 0 and/or to
the start count SC is possible at P2 (at the second preset). An exter-
nal or manual reset is possible at any time.
previous signal and the final signal. This means that when changing
the final signal, i.e. the preset P2, the previous signal will be auto-
matically adjusted or „trailed". This mode is well suited for switching
between rapid and creeping speed in the case of length measure-
ment applications.
www.baumer.com
The programming lines 51-54 are
only displayed for models with
interface
(7 data bits)
(7 data bits)
(8 data bits)
, the instrument switches back to the beginning
and simultaneously.
NE134
39