Collomix Xo 33 R duo Gebrauchsanweisung Seite 10

EN Proper use
The machine is designed for mixing liquid, granular and
powder-based building products such as paints, mortar,
concrete, adhesives, plaster, mixes containing silica sand,
mixing tool for the consistency of the material and the
when choosing the size of mixing tool (diameter/mixing
eter is selected, this may cause the machine/gear unit
to become overloaded and lead to damage as a result.
from the top down puts a greater strain on the electrical
Given the high torque levels generated by the machine, it
must not be used as a power drill.
The machine is not suitable for mixing materials contain-
ing graphite dust, brine or slurry. Mixing of these ma-
terials or substances may damage the machine beyond
repair.
Assembly
ensure that they do not come into contact with each
other.
To release or change the mixing tools, simply pull back
the handle-collar on the coupling and this releases the
mixing tool.
to be reversed (see page 2). This can be an advantage
for liquid materials. Please note, however: This places
Use the right
Make sure that the markings on
Check that the power supply shown on the rating
plate is the same as the mains power supply.
1.
-
2.
Always work with the ON/OFF switch fully pressed.
To stop working, release the ON/OFF switch.
Always reduce the speed when submerging the mixing
ing tool is fully submerged, increase the speed again to
ensure that the motor is adequately cooled.
During mixing you should guide the machine around the
material is completely mixed. Please follow the process-
The greater the viscosity of the material, the greater
the impact of the torque forces on the machine, so you
should be prepared for this when you carry out your
work.
If the mixing tool comes into contact with a surface (e.g.
ton (1).
Press the ON/OFF switch (2).
The more pressure you apply to
the ON/OFF switch,
the faster the machine will run.
The ON/OFF switch cannot be
locked!
-
-