Setup; Operating Instructions - Compex AYRE Bedienungsanleitung

SETUP

Unpack the case, take the product and adapter out, and charge the device before first use. Place your foot in the
wrap, zip up the boot, and secure the velcro to hold your leg in place. Make sure the wrap is snug, but not too tight.
Time/Mode/Chamber display area
OPERATING INSTRUCTION
TURNING ON/OFF THE DEVICE
• Hold the On/Off button for 1 second to turn on the device.
• The device will begin to operate in the default function/mode F1 to the default pressure setting. To change the
mode and pressure settings, read below.
• Hold the On/Off button for 1 second to turn off the device.
MODE F1
• The device will automatically inflate the four chambers one by one. The device will first inflate Chamber 1
(C1) to the preset pressure, followed by Chamber 2 (C2), Chamber 3 (C3) and Chamber 4 (C4). The left display
indicates the Chamber (C1, C2, C3, C4), and the right display indicates each chamber's air pressure and
changes from 00 to the preset value.
• After inflating to the preset value, all four chambers (C1, C2, C3, and C4) will stay inflated for 10 seconds, and
then deflate to zero simultaneously (the left display changes to show the total use time, and the right display
changes from the preset pressure to 00).
• After holding at zero pressure for 60 seconds (the left display shows the total use time, and the right display
shows 00), the above cycle repeats.
MODE F2
• Press the ON/OFF button to switch the function/mode from F1 to F2.
• F2 inflates all four chambers at the same time: The left display shows CH (indicating all 4 chambers), the right
display changes from 00 to the preset value, indicating the real-time air pressure.
• After inflating to the preset value, all four chambers (C1, C2, C3, and C4) will stay inflated for 10 seconds, and
then deflate to zero simultaneously (the left display changes to show the total use time, and the right display
changes from the preset value to 00).
• After holding at the zero pressure for 60 seconds (the left display shows the total use time, and the right
display shows 00), the above cycle repeats.
Power/ Mode selection button
Air pressure setting button
Air pressure display area
11