Switching Off The Burners Automatically - Pelgrim GKT814 Anleitung

OPERATION

Switching off the burners automatically

Unlocking a burner
A burner is locked when there is a 'b' in the display.
• Make sure that the hob is switched on.
• Press the leftmost – button and the child lock button simultaneously
for at least two seconds.
You will hear a beep, you can release the buttons. A '0' appears
above the burner touch control indicating that the burner can be
re-ignited.
When the burner does not ignite, check whether:
• the burner cap is placed correctly on top of the burner;
• the burner/spark plug is clean and dry.
If you have attempted to unlock a burner up to 5 times over a
period of 15 minutes, the code 'Flt06' appears above the touch
control. You are not permitted to make any further attempts to
unlock a burner for a further 15 minutes.
Switching off one burner
Press the + and - button simultaneously for 2 seconds of the burner
you want to switch off or use the – button to set the burner to 0.
The burner switches off and a flashing 'H' appears above the touch
control and will remain visible for a few minutes to indicate that the burner
is still hot.
Switching off all burners at the same time
Press the On/Off button.
All burners switch off, and the hob is now switched off. If a burner is
still hot, a flashing 'H' will remain visible above the corresponding touch
control for a few minutes.
It is possible to set a switch-off time for every burner. The burner will
then switch off automatically when the set time has elapsed. You
can only set the time when the burner is ignited (type GKT875RVSA/
GKT895RVSA/GKT814RVSA).
• The countdown starts as soon as the programming of the switch-off
time for a burner has been confirmed. If you do not confirm the set
time, the countdown will still start after a few seconds.
GB 9