Before Using The Appliance; Lighting The Burners - Pelgrim GKB 299 Anleitung

Before using the appliance

The fitting of the appliance should only be
carried out by a registered Corgi gas fitter.
During repair and cleaning the appliance
needs to be disconnected from the power
supply (electricity and gas). Remove the
plug from the wall socket or turn the switch
in the metre cupboard to zero. Turn off the
gas tap in the feeder pipe.
This cooking appliance is designed for
household use. It should only be used for
preparing meals.
When boiling and frying the hob gets hot.
Please pay close attention to small
children.
Grease and oil are flammable when over-
heated. Stay near the appliance when
preparing dishes.
Do not use the appliance to heat the
kitchen. This will produce a damp
atmosphere.
When a gas cooking appliance is being
used heat and moisture is produced in the
area where the appliance is situated. Make
sure that the area is sufficiently ventilated;
open natural ventilation openings or fit a
mechanical ventilator (extractor). When the
hob is used for longer periods extra
ventilation may be needed, such as an open
window or a higher setting on the ventilator
(extractor).
Things to watch for
Clean immediately
Any spillage should be removed
immediately, particularly red cabbage,
apple sauce and rhubarb. These can leave
permanent spots on the enamel or on
stainless steel.
Burning in of the enamel
The burners cause the saucepan supports
to get extremely hot. Over time the enamel
on the support points can burn in. This
cannot be prevented and is not covered by
the guarantee.
Burner caps
Check regularly to ensure that the caps of
the burners are properly in position on the
burner depressions; improper positioning
can make it difficult to light the burners,
give rise to an irregular gas flame, or
damage the burner caps.

Lighting the burners

Using the electrical spark switch
Press the knob of burner you wish to light in
and turn it to the left to the -symbol. The
spark switch will generate sparks and the
burner will light automatically. If the burner
fails to light after repeated attempts, check to
ensure that the burner cap is properly
positioned. The gas flame can now be
smoothly adjusted from high to low.
Operating the wok burner
The wok burner is eminently suitable for stir-
frying food and for frying and grilling meat. In
addition, you can use this burner for boiling or
blanching large quantities.
Owing to the high heat output of the wok
burner, it is less suitable for simmering food or
preparing sauces.
Saucepans
Use
The recommended saucepan diameters for
the various burners are:
For the high-speed burner, minimum 24 cm.
For the standard burner, minimum 20 cm.
For the low-speed burner, minimum 14 cm.
For the wok burner (special pan),
minimum 24-26 cm.
Wrong:
A great deal of heat is
lost along the sides of
the saucepan.
fig. 3
Right:
The heat is evenly
distributed over the
base of the saucepan.
fig. 4
Tip:
Cooking without a lid or with the saucepan
partially covered causes a great deal of
energy to be wasted unnecessarily.
Clean saucepans absorb heat more efficiently.