Pelgrim GKT814 Anleitung Seite 83

OPERATION
'time' appears in the timer display.
• Press the - or the + button for the ignited burner to start to set the
timer. This changes in increments of one minute.
'0.00' appears in the timer display and an indicator is illuminated in
the display of the burner.
• By pressing the - or + button set the number of hours from 1 to 9.
• Press the timer button again to start to set the number of minutes.
• By pressing the - or + button set the number of minutes.
• Finally press the timer button again when you have finished setting
the timer.
The indicator of the burner for which a timer has been set starts to
flash. The remaining time appears in the timer display with a 't' for
time, e.g. 't0.12'.
• While programming time you can reset the time '0.00' by
simultaneously pressing and the + and - burner button.
• You can view the remaining time for a burner by pressing the
timer button again. The time of the burner whose indicator light is
flashing, appears in the display. If you want to see the remaining
time of another burner, you need to press the timer button again to
select this burner.
• You can adjust the time by pressing the timer button, selecting the
correct burner by pressing the timer button and then pressing the
+ or - burner button to adjust the time.
• If you switch off the burner manually, the set switch-off time
disappears.
• You can also use the timer even if no burner has been lit.
• If both burners are lit in the case of type GKT832RVSA and are
linked to the timer, then the timer display will show the remaining
time for the burner that is to be switched off first. The indicator for
this burner will flash faster than the light for the other burner.
• In the case of type GKT831RVSA you can only use the right-hand -
and + button to set the time. This time will then apply to both rings
if they are both lit. If only the inner ring is lit, then the remaining time
only applies to this ring.
GB 11