Programming Bus-2 Address; Led Indicators; Installation Guidelines; Control Panel - Honeywell 023350.17 Montage, Anschluss, Anleitung

28
5. Programming
BUS-2 address
The DIP switches located in the Door controller module
(address switch S1) are for setting the BUS-2 user
address. The individual codes can be found in the
programming protocol of the intrusion detection control
panel.
The address of the users (IK3 operating units) is
allocated automatically by the corresponding function in
the programming of the control panel.
Indicated switch position =
6.

LED indicators

JP22
Address
switch
BUS-2
LD1 LD2
Yellow
Green
7.

Installation guidelines

The BUS connection lead
the diagram below.
The corresponding line cross-sections can be found in the
detection control panel (Chapter on lines). The shield terminal should also be kept as short as
possible to avoid the risk of an unintentional short circuit.

Control panel

Data
0 V
BUS-2
U_b +12 V DC
0 V
Shield
Mounting and Connection Instructions Door controller module for MB
Address 5
Normal operation:
- RAM is initialized when started
- When in operation, module is
initialized by the central control
unit.
Boot loader active
Firmware downloaded
Testing firmware after update
Faulty firmware
must be a shielded cable stranded in pairs and the cores laid according to
Address switch S1
set! ON
LD1 LD1
LD2 LD2
LD1 LD1
LD2 LD2
LD1 LD1
LD2 LD2
LD1 LD1
LD2 LD2
LD1 LD1
LD2 LD2
Installation Manual
BUS-2
32
16
8
Address value
4
2
1
OFF Switch position
aus aus
blinkt 1x blinkt 1x
aus aus
blinkt 50ms / 2s blinkt 50ms / 2s
immer aus immer aus
of the intrusion
Module
Data
0 V
+12 V DC
0 V
Shield