Taking The Helmet Off; Before Each Driving Session; Inspecting The Helmet; Inspecting The Chinstrap (With Helmet On And Fastened) - SCHUBERTH SP1 CARBON Gebrauchsanweisung

2. TAKING THE HELMET OFF

1. Pull the red tab of the double-D-ring fastener to loosen the chinstrap.
2. Grasp the metal rings and pull these apart.
3. Thread the chinstrap end out of the double-D-ring fastener.
4. Next, grasp the bottom ends of the chinstrap and pull them apart.
5. You can now easily pull the helmet off your head.
E. BEFORE EACH DRIVING SESSION
For your own safety, check the following three points before every driving
session:

1. INSPECTING THE HELMET

Regularly inspect your helmet for damage. Small scratches do not affect the
protective function of your helmet. Check the black painted EPS shell inside
for any white cracks. In case of presence, substitute the helmet.
2. INSPECTING THE CHINSTRAP
Step 1:
Check that the chinstrap runs under your chin.
Step 2:
Insert your forefinger under the chinstrap and tug it.
• If the chinstrap is loose against the chin, it has been set too long
and must be pulled tighter.
• If the chinstrap yields or comes loose, it has not been properly
fastened. Open the chinstrap completely and thread the loose end,
as described on pages 12, through the double-D-rings.
Then pull the chinstrap taut and repeat the check.
Step 3:
If your bodyweight has significantly reduced, you should check that
your helmet is still the correct size for you (see page 7).
(with helmet on and fastened)
19