Adjusting The Seat Position; Adjusting The Seat Height - Cube CARGO HYBRID 2020 Originalbetriebsanleitung

Bild:
Adjusting the handlebar height
Observe the minimum insertion depth
of the handlebar stem (see chapter
7.1.2 „Note the minimum insertion depth
(seat post and handlebar stem)").
3. Fix the adjustment by closing the quick-release
on the handlebar stem again.
4. Make sure that the quick-release is in maxi-
mum contact with the handlebar stem and
is securely closed.
Bild:
Handlebars height fixed
7.3

Adjusting the seat position

To adjust the seat position, you need a
hexagon socket spanner and a torque
wrench of the appropriate size.
To adjust the horizontal position or inclination
of your seat:
1. Loosen the clamping bolts by a few turns
until the seat can be moved easily and/or
the inclination can be adjusted.
2. Move the seat to the desired position.
When changing the horizontal position,
pay attention to the adjustment range
on the seat struts.
CARGO HYBRID
3. Fix the adjustment by tightening the clamping
screws as follows:
Tighten the clamping screws alternately by
a quarter to half turn until the prescribed
torque is reached (see chapter 3.5.2 "Torques
and screw connections").
4. If the marking on the seat post cannot be
found in chapter 3.5.2 "Torques and screw
connections" under "Tightening Torques,"
consult your specialist bicycle dealer.
7.4

Adjusting the seat height

The seat post is fixed with a clamp in
the seat tube of the frame.
The clamp is fixed with a quick-release
lever.
When attaching an (additional) clamp
(e.g. for anti-theft protection), observe
the information in the manufacturer's
instructions for the clamp.
1. Open the clamp by unfolding the quick-release
on the seat tube to the outside.
2. Move the seat and seat post to the desired
position for your seat height.
Observe the minimum insertion depth
of the seat post (see chapter 7.1.2 „Note
the minimum insertion depth (seat post
and handlebar stem)").
Bild:
Adjusting the seat height
| 35